SKF GAC120 F Angular Spherical Plain Bearing - 120 mm ID, 180 mm OD, 38 mm Width cut resistant gloves Use puller to remove the

Use puller to remove the battery terminal clamp without damaging the battery post Works on corroded spring-type clamps Loosen the clamp bolt

410 Thread Size 5/8-18 Material Steel Stud Length (Decimal Inch) 1

The pulling jaw sets of series 70-S are suitable for bearing pullers of series 70 and are used for non-destructive removal of deep groove ball bearings without dismantling the shaft

The Whittet-Higgins BH-05 BEARHUG is a self-locking bearing locknut that threads onto a bearing-mount shaft to axially position

SKF GAC120 F Angular Spherical Plain Bearing - 120 mm ID, 180 mm OD, 38 mm Width cut resistant gloves Use puller to remove theAngular Spherical Plain Bearing sealed design Angular Spherical Plain Bearings can accommodate heavy loads in both directions. They are self aligning and accommodate misalignment and shaft deflections, with virtually no increase in friction or temperature. The sealed design provides protection against contamination. Suitable for use in a wide range of industrial applications where reliability and performance are essential.